Bailey infi 90 40 Series, Hardware Manual

Page: 113 / 132

COMPONENT DESCRIPTION AND REPLACEMENT
IIDOP05A OPTICAL DISK
6 - 30 WBPEEUI220754A0
®
information and a description of the archiving storage devices.
Refer to the
Operation instruction for procedures (Table 1-3 ).
Refer to the manufacturer’s documentation for repair and
troubleshooting information.
IIDOP05A OPTICAL DISK
To remove the optical disk drive from the driver cabinet, refer
to Figure
6-21 and follow these steps.
NOTE: The right hand unit from the front of the cabinet is for the bot-
tom card cage and bottom power entry panel.
1. Remove power by turning off the breaker at the power entry
panel.
2. Label and remove the cables from the unit.
3. Note the SCSI bus address on the switch on the back of the
unit.
4. Remove the two screws fastening the front of the optical
disk mounting plate to the shelf.
5. Carefully slide the optical disk out the front of the cabinet.
6. Remove the four screws mounting the optical disk to the
mounting plate.
NOTE: When replacing the unit, verify that the SCSI bus address is
the same as the address in Step 3.
Figure 6-21. Driver Cabinet Optical
Disk Drive Removal
OPTICAL DISK DRIVE
MOUNTING SCREWS (2)
REAR VIEW
TP36218A