INSTALLATION
PERIPHERALS
3 - 24
WBPEEUI220754A0
®
A maximum of four logging printers can be accessed by the
IIOIS42 console. For OIS consoles, connect the printers to a
terminal server (IIPRS02) on the ethernet link.
The line cord must have isolated safety ground referenced to
the same point as the OIS electronics safety ground, without
connection to conduit/structural ground. The AC receptacle
must be an isolated ground duplex type (i.e., Pass and Sey-
mour IG6200 or equivalent).
This section gives the steps to connect the printer. Printer
installation consists of configuring the printer through the
menu and connecting cables. Connect the power and commu-
nication cables at the back of the printer. Connect the power
cable into a local AC outlet. For more information, refer to the
manufacturer’s documentation.
1. Attach one end of the printer cable (Table
) to the DB25
serial connector of the printer. Attach the other end to the ter-
minal server. Tighten the connector hood screws.
NOTE: Step 1 applies only to IIPRT02, IIPRT03, IIPRT05 and
IIPRT09
_
printers. For cabling information on the IIPRT08B and
IIPRT10
_
printers, refer to Figure
and the appropriate section.
2. Turn printer power on.
3. Press
to get local
(Lo)
mode.
4. Press and hold
to print the current setup.
5. Select the applicable printer from the following list. If the
setup values in the text do not agree with the printed listing for
the printer, select item 1 through 9 for the GENICOM printers
or the line to be changed for the OKIDATA printer and make
the appropriate changes.
IIPRT02, IIPRT03, IIPRT05 AND IIPRT09
_
PRINTERS
Figure
shows the printer cable configuration for IIPRT02,
IIPRT03, IIPRT05 and IIPRT09
_
printers.
Refer to Table
for IIPRT02 (GENICOM 3410 XLS) printer
setup values.
Press the number 0 to return to normal operation. To continue
modification, select 1 through 9.
Refer to Table
for IIPRT03 (GENOICOM 3410 XCQ) printer
set up values.
Press the number 0 to return to normal operation. To continue
modification, select 1 through 9.
ON LINE
PRG
