39
39
8. Move the router head in the X+ direction so that it is approximately at the end of the
sacrificial board.
9. Move the sacrificial board so that it lines up with the point of the router bit.
10. Place tape on the bed of the machine at the edge of the sacrificial board.
11. Move the router head to the end of the machine furthest X and Y position. The router head
will be out of the way and allow you to have access to the bed of the machine.
12. Remove the sacrificial board.
13. Clean the bed of the machine so that there are no wood chips or dust. Apply double-sided
tape to the bed of the machine using the tape that you have just applied as reference. You
need to apply three or 4 strips of double-sided tape to the bed of the machine with sufficient
length so that the sacrificial board is attached along its complete length and width.
14. Clean the sacrificial board so that the surface will adhere to the double-sided tape.
15. Remove the backing from the double-sided tape.
16. With 2 people, lift the sacrificial board over the table and lower so the reference tape that you
applied to the bed of the machine aligns with the corner and edge of the sacrificial board.
17. Lower and press down so that the double-sided tape sticks to the sacrificial board. Do not
worry if the sacrificial board is not perfectly aligned with the tape as you will have to reset the
home position. The clamps can also be used to clamp the sacrificial board to the bed of the
machine.
Summary of Contents for WR-84V-ATC
Page 48: ...46 46...
Page 51: ...49 49 ELECTRICAL SCHEMATIC...
Page 52: ...50 50...
Page 53: ...51 51...
