34
34
3.
With the table powered On, Press the “Menu” key, scroll down to the “Operation” option and
press OK.
4.
Scroll up to the “Tool Change Parameter” and press OK.
5.
Scroll to “Current ToolNo.” and press OK. The tool number shown must match the empty
magazine location. As an example, if magazine number 1 is empty and is installed in the
spindle; the current tool number will be 1.
6. Using the digit keys, set the current tool to number 3.
7. Remove tool 3 from the tool holder, grasp the tool
that is in the spindle and then press and hold the
Red Manual release switch (A) on the side of the
spindle to release that tool. Release the switch
when the tool is out of the spindle.
8. Place that tool back into the magazine in its
correct location.
9. Press and hold the Red manual release switch
(A) and insert tool number 3 into the spindle.
10. Hold the tool up into the spindle and release the
manual switch. When the spindle clamps onto the
tool, it may be released.
11. The tool has now been manually changed and
the controller has been set to know that the tool
has been changed. In this case, tool 3 has been
installed in the spindle and programed into the
controller.
12. If this tool is being changed because a new bit
has been installed, then proceed with the next
steps to measure the tool.
13. Press the combination keys of
+
(Shift + X+) to enter the tool measurement
operation. When asked, press the
(OK) key. The spindle will move to the position
over the tool touch sensor and lower and touch the sensor. While lowering, the speed will
change from a fast speed to a slow speed. This is both normal and required. If the spindle is
lowering at the fast speed when the bit contacts the touch sensor, it will crash the touch
sensor. This would indicate that the bit that is installed is too long for this system. The bit
should not extend out of the collet more than 2” (50mm).
A
Summary of Contents for WR-84V-ATC
Page 48: ...46 46...
Page 51: ...49 49 ELECTRICAL SCHEMATIC...
Page 52: ...50 50...
Page 53: ...51 51...
