29
29
4. Press the
(Z=0) key to set the Z coordinate work position.
5. If the current XY location is not the desired starting point, use the X and Y coordinated keys,
to move the spindle to the desired starting location.
6. When the center of the cutting tool is located at the desired starting point, press the
(XY=0) key. This will set the controller coordinates to zero and set this as the X and Y
workpiece origin.
Loading a Program
The console has a USB port located on the right side near the top.
Note: Never use a memory stick with a format other than FAT32. If you do it will
crash your machine computer. Contact technical support should this occur. It is recommended
that if you use additional memory sticks, they be formatted to FAT32 and a file allocation of
4096 identified for NC machine use only.
IMPORTANT
:
Ensure that the spindle is clear of any persons, parts, pieces, and
or tooling. The spindle will start to turn and could cause injury.
1. If using a new file, load your *.nc program onto the USB flashdrive and plug the USB into the
USB slot in the console.
2. Press the
(menu) key. The menu screen will display the file location choices. Local File
are files saved to the controller memory. USB Files are those files saved on the USB disk.
1
Local File
2
USB Files
3
Operations
4
Oper Param
CAUTION:
The router head with the spindle turning will be moving
around the table once the program is loaded. Verify that the table is clear and that the
tooling will only contact intended material which is properly secured to the table.
Failure to clear the surface or secure the material can cause serious injury.
Summary of Contents for WR-84V-ATC
Page 48: ...46 46...
Page 51: ...49 49 ELECTRICAL SCHEMATIC...
Page 52: ...50 50...
Page 53: ...51 51...
