34
34
•
Kerf: According to the cutting gap width, users set Kerf Gap compensation (the value should
be half of the cutting gap) to ensure the dimensional precision, the system will generate a new
path automatically to make compensation to the workpiece. Before cutting a workpiece, you
can modify the kerf gap value, once cutting begins, you are not permitted to modify the value.
•
Corner speed: Plate thickness affects the cutting ti
p’s ac/dc rate when moving. The angle
between the end of a cut-
point line’s tangential direction and the direction of the tangent line
of the beginning of the next cutting point, and the thickness of the plate determines cutting tip
speed at the transition.
If the
normal cutting speed is V, angle is α, plate thickness is h, then cutting tip speed in at the
time of intersection is V
x
V
x
=
αh
V
50
𝜋
Note:
This is for the corner speed compensation. The unit of measure is mm. The
max thickness value is 100mm for this function. For corner speed compensation, the maximum
value is 100mm. The programming will accept a maximum value of 100mm.
•
Demo Run Speed: This is the cutting torch speed when doing a Demo when changing the
Cutting type to Demo. The unit of measurement is mm.
•
Cutting Type: There are two cutting types: Oxygen fuel gas and Plasma parameters. You can
press [←] or [→] to switch with them.
Flame Parameters
The Oxy/Fuel parameters are not used.
