22
22
•
Press F2 to mirror along the vertical axis (Y axis)
•
Press ESC to exit mirror operation
Angle Adjustment
Press F2, the system will prompt:
F1
Steel-plate adjust
F2
Enter angle
•
Press F1 to adjust steel plate
•
Press F2 to enter angle directly
•
Press ESC to exit angle adjusting
Steel Plate Adjustment
After entering the steel plate adjustment menu, the system will prompt:
X-start
Y-OK
ESC-exit
Adjust X:
+00000.00
Adjust Y:
+00000.00
Angle:
+00000.00
Here, you can manually move the cutting tip to the edge of one side or a corner (preferred) of the
plate. When the cutting tip is moved to a good position, press the [X] key to set the current point
as the starting point of the angle correction.
Then manually move the X axis on the same edge to the far corner. Move the Y axis just enough
to place the tip at a similar point on the material as the first point.
Press [Y]. The system will automatically calculate the current offset angle of plate, and then
automatically rotate graphics.
