17
17
In the cutting interface, on the operation panel, press the number keys [1]
– [9], the speed will
quickly adjust to the corresponding percentage of the key pressed times 10. For example, press
[3], adjust to 30% of the speed limit you have set, press [8], adjust to 80% of the speed limit you
have set.
Forward
In the automatic function screen, press key [F2], the machine starts to move without real cutting.
The process does not include any ignition, perforation and any other I/O working. The machine
just moves the torch according to the graphic figure.
The function can be used to check the trail and code before you start the real cutting process.
Press the [F10]
“STOP” key to stop the trial process if you want.
Backward
During the running process, if you want to go backward according to the origin trail to (maybe the
material was not cut through), you can follow the following direction:
•
First, press [F10]
“STOP” key to set the machine at pause status.
•
In the automatic function screen, press [F3] key (Back) to make the machine go backward
along the original path.
•
When the torch reaches the position you need, press
[F10] “Stop” key to stop it. You may
press the [F2] key to go forward if the machine went backwards too much.
Note: The backward or forward function may be used repeatedly to make the
machine reach an ideal position.
•
When the torch reaches the position you need, press [F9]
“START” key again, if the current
cutting code is G01, G02 or G03, system will automatically perforate before performing these
procedures, and then continue the current program, if the current row is not G01, G02 or G03,
the system will directly continue the current line program.
