18
18
Edge Cutting / Offset Cutting / Return
When the torch is not on the actual path of the current workpiece, the system will prompt the
operator to identify which action should happen next.
There are two ways in which this situation will occur.
1. When the common parameter "edge perforation"
selection is "Yes" and the next processing line G-
code is M07, the system will automatically be
suspended. At this time, the torch can be manually
moved to any edge of the plate. Press the [F9]
“Start” button, the system prompt will be displayed.
2. When the processing is paused, due to mechanical
failure or other reasons, it needs to move the torch out of the actual path of the workpiece, the
system prompt will be displayed.
•
If pressing [G], the system returns the torch back to the paused point and will continue to cut
from that point. This feature is particularly useful for thick steel plate, it can reduce the preheat
time and increase cutting efficiency. This function is commonly used for the edge perforation
function.
•
If pressing [X], the system considers the current point is the paused point, it will continue
cutting it. That is, the system offsets the cutting point. When the cutting machine is paused or
a power outage, if the cutting tip or steel plate with the pan has been offset or the user would
like to think that it is offset cutting, you can press this button.
•
If pressing [Y], the system only returns to the paused point quickly, and then break off. During
the cutting process, if discovery cutting torch malfunctions, or other issues, need to move the
cutting tip out of the cutting region to overhaul. After the maintenance, this key can be pressed.
Then return to the paused point, press the
[F9] “Start” button, the system automatically
continues cutting.
Back to Reference Function
When pausing or stopping the cutting process, if the
[F3] key is pressed the system will prompt to question if
you are sure or want to cancel.
Pressing the Enter key will cause the system to
automatically return to the starting point of the
workpiece.
The system automatically switches to processing at the
main interface and waits for further user action.
