23
23
OPERATION
Safety guard must be properly positioned with the
limit switch roller in the detent of the adjustable
ring or the machine will not run. The electrical
enclosure cover must be closed and locked, and
the emergency stop button must be reset by
turning clockwise (cw).
1. Load and secure the piece part to the table.
2. Secure drill or tapping bit in the chuck.
3. Unlock the table, set to desired position, and
lock.
4. Adjust the safety guard as necessary.
4. To set the depth stop, use the down-feed
handle (A), to bring the tip of the drill or
tapping bit to the surface of the work piece (B)
and hold this position. (This is zero position.)
The quill lock (C) may be used (tightened) to
old the quill in this position.
5. Rotate knob (D) to set the drill depth on the
scale with indicator (E).
6. If used, release the quill lock (C) and allow the quill to raise to the full
up position.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
A
D
E
C
B
Summary of Contents for DP-1200VS
