Baileigh Industrial DP-1200VS, Operator'S Manual

Page: 27 / 40

25
25
Removing Tooling from the Spindle
1. Disconnect machine from the power source.
2. Place a piece of wood on the table for protection.
3. Position the work table approximately 10” under the bit and
lower the spindle about 6”.
4. Place the drift key (customer supplied) (AI) into the slot (AJ) of
the quill and tap the end of the drift key with a hammer until
the bit or chuck arbor falls out.
LUBRICATION AND MAINTENANCE
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
On a weekly basis clean the machine and the area around it.
•
Lubricate threaded components and sliding devices.
•
Apply rust inhibitive lubricant to all non-painted surfaces.
Note: Proper maintenance can increase the life expectancy of your machine.
Lubrication
•
Keep quill and column lubricated with light oil. Use 20 wt. non-detergent oil for oil lubrication.
•
Use a general purpose grease for grease lubrication.
Daily Maintenance
•
Check daily for any unsafe conditions and fix immediately.
•
Check that all nuts and bolts are properly tightened.
•
Check that the guard and emergency stop are in good working order.
•
Do a general cleaning by removing dust and metal chips from the machine.
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
AI
AJ