24
24
7. Select either the drilling or tapping mode with selector switch (F).
8. Press green start button (G) to begin spindle rotation.
9. Spindle speed is set with knob (H) and can be read on the digital indicator (I).
10. Turn ON the coolant by using the push button switch on the left side of the drill head.
11. Use the quill feed handle to start drilling or tapping.
12. While tapping, the spindle will reverse rotation when the depth stop is reached, or when the
Tapping Reverse (J) button is pressed. The quill will also the reverse direction to lift the tap
out of the work piece.
Note: In general, use low speeds for tapping. By tapping at high RPM there is a
danger of damage to the piece part or the tooling. While tapping, the tool can be backed out at
any time by pressing the reverse button (AB).
13. At the end of the operation, press the red stop button (G) to turn OFF the machine.
IMPORTANT:
In the event of incorrect operation or dangerous conditions, the
machine can be stopped immediately by pressing the E-STOP button (K). Twist the button
clockwise (cw) to reset.
F
K
I
H
J
G
Summary of Contents for DP-1200VS
