Bahco DTC Series, Original Instructions Manual

Page: 4 / 42

6 7
DTC12340 DTC12340
Note: Calibration menu is password protected. Contact the BAHCO / SNA Europe After Sales
regarding Calibration.
BATTERY REPLACEMENT
Replace with three “AA” cells only.
Do not attempt to recharge alkaline cells.
Do not mix different battery types.
Replace all batteries at same time.
Store DTC in dry place.
Remove batteries when storing DTC unused longer than 3 months.
Note: When Replace Battery screen is displayed DTC will no longer operate until batteries are replaced.
Only POWER button functions which immediately turns off DTC.
LCD Contrast Selection LCD Contrast Screen LCD Contrast Screen
Press
ENTER
button
Press
ENTER
button
to Exit
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
CONTRAST: 40 CONTRAST: 80
UP/DOWN
Buttons
to select
from
20 to 80
Calibration Menu Selection Enter Password Screen Invalid Password Screen
Press
ENTER
button
Press
ENTER
button
to Exit
EXIT
CYCLE COUNT
SETTINGS
CALIBRATION
ENTER PASSWD
0 0 0 0 0
INVALID ID PASSWD
PRESS TO EXIT
Press
ENTER
button
5x
BATTERY
COMPARTMENT
BATTERY
SLIDE- OUT
COMPARTMENT
MAIN MENU
Main menu displays DTC operational information.
1. From torque measurement screen, press and hold ENTER button for 3 seconds.
2. Use UP /DOWN buttons to highlight menu selection then press ENTER button.
Menu Selections:
EXIT - Exits main menu and returns to torque screen.
CYCLE COUNT - Displays torque cycle count screen.
SETTINGS - Displays DTC settings menu.
CALIBRATION – Displays password screen (see Calibration manual).
3. To exit main menu and return to torque measurement screen, press ENTER button while EXIT
menu selection is highlighted.
Note: Sleep mode turns off the DTC to conserve battery power. Do not apply torque while in sleep mode.
0.00
1.PEAK FT‐LBS
Measurement Screen Main Menu
Main Menu
Sleep Time selection
Settings Menu Selection Show Info Selection
Cycle Count Screen
Sleep Time Screen Sleep Time Screen
Cycle Count Screen
Show Info Screen
ENTER
button
held
Press
ENTER
button
Press
ENTER
button
Press
ENTER
button
Press
ENTER
button
Press
ENTER
button
to Exit
Press
ENTER
button
to Exit
Press
ENTER
button
EXIT
CYCLE COUNT
SETTINGS
CALIBRATION
EXIT
CYCLE COUNT
SETTINGS
CALIBRATION
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
EXIT
CYCLE COUNT
SETTINGS
CALIBRATION
EXIT
SHOW INFO
SLEEP TIME
LCD CONTRAST
COUNT: 12
CLEAR
EXIT
SLEEP TIME
5 MIN
EXIT
SLEEP TIME
8 HR
EXIT
COUNT: 0
CLEAR
EXIT
UP/DOWN
buttons
UP/DOWN
buttons to
select from
2 min.
to 8
CAL: 2014/01/01
CWOI: 0.00
CWOR: 35
CW1I: 250.10
CW1R: 15931
CCWOI: 0.00
CCWOR: 10
CCW1I: 250.10
CCW1R: - 15870
TQZ: 18
OVR CNT: 0
VER: 1.0.0