Instruction 0024-9395
5
Fyrite Pro
3.0 SETTING UP THE ANALYZER
3.1 Preliminary Steps
Before using the analyzer . . .
• Check batteries (Section 3.2)
• Connect probe to analyzer (Section 3.3)
• Check setup (Section 3.5)
3.2 Checking & Replacing the Bat ter ies
Install fresh batteries as described below. Check the analyzer for sufficient
charge prior to each use. Replace the batteries if the low-battery symbol
appears in the lower right corner of the screen. To re place the bat-
ter ies:
1. Remove battery cover from back of analyzer.
2. If old batteries are installed, remove them and properly discard.
3. Observing the polarity markings inside the battery com part ment,
install four ‘AA’ Al ka line bat ter ies as shown in Fig ure 3-1.
4. Replace battery cover.
Figure 3-1. Battery Installation
Remove battery cover by
pushing down on cover
and sliding it outward
