BaByliss Smooth & Wave C2000E, Manual

Page: 10 / 92

10 11
• IMPORTANT! If the appliance is not released from the hair after the
finish audio indicator, it will beep continuously. To continue using the
appliance, remove from the hair and use as normal (Fig 5-6).
• Release the handles fully and smoothly pull the appliance away from
the head to reveal the chosen wave (Fig 7-8).
• To allow the wave to set, do not comb or brush the hair until it cools.
• Repeat around the head until you have the amount of waves desired.
• After use, switch off and unplug the appliance. Allow to cool before
storing.
Creating Smooth Styles
• Ensure the hair is clean, dry and free of dry shampoo, hairspray, mousse,
spray wax, styling dust and all other styling products.
• Comb through to remove any tangles and divide the hair into sections,
no bigger than 2cm wide.
• To turn the appliance on, slide the switch to the temperature setting
suitable for your hair type (See Temperature Settings). IMPORTANT!
Always allow the appliance to heat up fully before use. The LED light
will flash until the temperature setting has been reached.
• Select the smooth setting by sliding the switch to smooth mode (See
Wave or Smooth Settings).
• Always insert the hair into the appliance with the plate part facing
towards the head. Place a section of hair between the straightening
plates, close to the roots (Fig 9-10).
• IMPORTANT! The neat section of hair must be inserted evenly on to the
straightening plates, beyond the hair stopper (A) until it reaches guide
(B). If too much hair is placed into the appliance opening and outside
of hair stopper (A) the appliance will beep continuously. To continue
using, remove the appliance from the hair and insert smaller sections
of hair (Fig 11-12).
• Caution! If the appliance is used incorrectly, in certain instances a slight
tangle can occur. Should a tangle occur, firstly turn the appliance off
and refrain from pulling the appliance away from the hair. Gently tease
the hair out from the ceramic chamber until fully released.
• Firmly close the handles together to allow the hair to be drawn into the
ceramic chamber.
• IMPORTANT! Once the hair has begun to be drawn into the ceramic
chamber hold the hair firmly between the straightening plates and
immediately slide smoothly and slowly down the length of the hair
from root to tip (Fig 13-14).
• IMPORTANT! If the appliance is not released from the hair it will beep
continuously. To continue using the appliance, remove from the hair
and use as normal.
• To allow the section to set, do not comb or brush the hair until it cools.