![background image](http://html1.mh-extra.com/html/baby-lock/bnt10/bnt10_instruction-and-reference-manual_462364271.webp)
Using the Optional Cap Frame
269
7
—————————————————————————————————————————————————————————————————————————————————————
Installing the embroidery
frame holder
After embroidering using the cap embroidery frame
is finished, remove the needle plate spacer and cap
frame driver, and then re-attach the embroidery
frame holder.
1
Remove the needle plate spacer.
1
Needle plate spacer
2
Loosen the two lower thumb screws.
1
Thumb screws
3
Remove the two upper thumb screws
1
Thumb screws
4
Remove the cap frame driver.
Note
●
Be careful that the cap frame driver does
not hit any nearby parts, such as the
presser foot.
5
With the hole on the sweat guard holder
aligned with the centerline of the guiding
plate, insert the two thumb screws removed
in step
3
into the holes at the top, and then
tighten the thumb screws.
1
Hole on the sweat guard holder
2
Centerline of guiding plate
3
Holes on the top
• Insert the thumb screws into the holes
where the cap frame driver that was
originally installed (holes that the thumb
screws were removed from in step
2
on
page 256).
X
The movable section of the cap frame
driver is secured.
Summary of Contents for BNT10
