ENGL
ISH
DE
UTS
CH
FRANÇAI
S
NEDER
LAND
S
Error
code
Description
Potential causes
Possible source
Action
7
Pedal signal/
torque
error when
powered on
It is possible that the system
is fine but the rider mistakenly
triggered error 7 by putting feet
on the pedals when turning
on the display. This accident
can be cleared by restarting
the display with the feet off the
pedals.
Speed/
Torque sensor,
Controller
Restart the display keeping
both feet OFF the pedals.
10
Temperature
error
Temperature Controller
>90°C or < -20°
Controller
Replace the controller
11
Pedal torque
error
during pedaling
Controller or torque sensor
malfunction.
Controller,
torque sensor
Check plug 1 (see page 73).
Remove the battery, disconnect
plug 1 by untwisting the two
steel rings. Blow out the plug
and connect both plugs again
with the arrows facing each
other. Twist the steel rings
back together again and place
the battery back in its original
position.
For the 09C system (Babboe Max-E) there are additional error codes.
Error
code
Description
Potential causes
Possible source
Action
5
Motor Stall
Gate driver malfunction
Motor, Controller
Check plug 2 (see page 73).
Remove the battery, disconnect
plug 2 by untwisting the two
steel rings. Blow out the plug
and connect both plugs again
with the arrows facing each
other. Twist the steel rings
back together again and put
the battery back in its original
position.
6
Battery
cell voltage
calibration
data error
Malfunction in the electrical
components for voltage
detection.
Controller
Replace the controller
9
Communication
error
No communication between
display and controller or
speed/torque sensor. The TX,
MX, MCU or fuse components
might be damaged.
Display,
Controller,
speed/torque
sensor
Check plugs 1, 2, and 3 (see
page 73) as follows. Remove the
battery, disconnect the plug by
untwisting the two steel rings.
Blow out the plug and connect
both plugs again with the arrows
facing each other. Twist the steel
rings back together again. Put
the battery back in its original
position.
57
56
