B2 HVA120, User Manual

Page: 38 / 69

5 Test Procedure
38 DHV0078 b2 EN © b2 electronic GmbH
Running a Manual Test
Steps MR1-MR6 describe how to run a test in the manual mode .
Step Procedure (run manual test) Example
MR1:
START
Start the test when test parameters displayed on the
“Manual Test” screen are correct.
Rotate navigation knob until the “START” field is
highlighted.
•
To run the test, push in knob .
MR2:
HV activation
Once the activation screen appears,
•
Press the HV switch within 10 seconds.
If the HV switch is not activated within the 10-second
window, the “Manual Mode” screen will reappear.
MR3:
Test startup
“Startup” appears on the screen to indicate that the
HVA is initializing the test.
MR4:
Set test voltage
(if not preset in step
MS6)
Rotate navigation knob to modify the voltage value.
•
Voltage limits see 3.1 – Technical Specifications
MR5:
Test
Test begins automatically
The bottom of the screen indicates the lapsed time
•
T: lapsed time/total test duration
MR6:
Test end
Display indicates end of manual test
Manual Test Sine 0.1Hz
Timer: 15 min.
MAIN SETUP Trip out on Arc
START
0.0
kV
rms
ATTENTION
High Voltage!
Press I/O Button to
switch ON High Voltage
Manual Mode Sine 0.1Hz
STOP T: 00:00 / 15min
0.0
kV
rms
0.0kV
0.0µA
Startup
Manual Mode Sine 0.1Hz
STOP T: 00:00 / 15min
85.0
kV
rms
0.0kV
0.0µA
Manual Mode Sine 0.1Hz
STOP T: 00:03 / 15min
85.0
kV
rms
76,1kV
585µA
57.1nF
13GΩ
Manual Mode Finished
Manual Mode Test Seq.
finished successfully
Sine 0.1 Hz
Test Voltage: 64.0 kVrms
Test Duration: 15 min
OK