B.S. Service PI 58 L C E2 T, Operating Instructions Manual

Page: 29 / 68

Minder press the“ + ” and “ - ” keys simultaneously.
On the “ B1 ” and “ B2 ” displays the remaining time
will appear.
- When time is up an acoustic signal beeps and the
timer displays flash. Any key can be selected to stop
the acoustic signal. If you leave the acoustic signal
it will deactivate after about 2 minutes.
To deactivate the Minute Minder function before
the set time , press the “ + ” and “ - ” keys simultaneously.
By selecting the “ - ” key a second time the time goes
to zero. After that the cooking zone will continue its
standard function.
It is possible to use the Minute Minder and the Timer
simultaneously.
• Booster:
The appliance is fitted with a Booster system which
can be used to speed up cooking times through the
application of a power level which is greater than the
nominal value, within a defined period of time.
1- To activate it, switch on the concerned cooking
zone bringing the power level to 9 .
2- By selecting the “ + ” key on the display the letter
“ P ” will appear.
- The Booster can be activated simultaneously on all
the enabled zones.
- The Booster function will be active for about 5
minutes, after which cooking will continue at level 9 .
- In order to stop this function, select the concerned
cooking zone and the “ - ” key until you reach the
desired level.
- All operations will be combined with a “BEEP” acoustic
signal.
- The Booster might not turn on if the cooking zone
was activated previously with high temperature levels.
• Integrated power control (Fig.6):
Each phase (this is divided into two zones in a vertical
line: F1 e F2 ) is capable of using a maximum power
of 3,700W.
If this is exceeded for example by activating the
Booster, the software automatically lowers power
of the previously selected zone until it reaches the
allowed power level.
The display of the zone with limited power will begin
to flash for about 3 seconds. During this time it is
possible to modify the power level.
• Maintenance (Fig.3):
Remove any residues of food and drops of grease
from the cooking surface using the special scraper
supplied on request.
Clean the heated area as thoroughly as possible using
SIDOL, STAHLFIX or similar products and a cloth/paper,
then rinse with water and dry with a clean cloth.
Using the special scraper (optional) immediately
remove any fragments of aluminium and plastic
material that have unintentionally melted on the
heated cooking area or residues of sugar or food with
a high sugar content. In this way, any damage to the
cooktop surface is prevented.
Under no circumstances use abrasive sponges or
irritating chemical detergents such as oven sprays or
stain removers.
T H E M A N U FA C T U R E R D E C L I N E S A L L
RESPONSIBILITY FOR EVENTUAL DAMAGES
CAUSED BY BREACHING THE ABOVE WARNINGS.
- 29 -