___________________________________________________H3000 Pilot Handbook
HB-3001-02
97
Fault 101 – Pilot Compass Failure
Fault Description
No valid data is being received from the Halcyon Gyro-Stabilised
Compass (HGSC) sensor connected directly to the Pilot computer.
Remedial Action
1)
Is an HGSC sensor in use?
Yes go to step (3)
No
go to step (2)
2)
Ensure that the Heading Source (SETUP
X
COMMISSIONING
X
HEADING SOURCE to the correct value for the compass sensor in
use.
3)
Check all wiring connections to the compass unit. There should be
both a sensor cable AND a 12V supply cable, see page 87 or 88
Fault 102 - Rudder Sensor out of Range
Fault Description
The signal from the rudder reference unit is outside the limits set during
commissioning. This usually indicates either a worn sensor or loose
components.
Remedial Action
1)
Check installation of rudder reference unit for slack or loose fittings.
Replace any worn parts and secure any loose items. If the position of
any part has been changed it is necessary to follow the Dockside
Commissioning procedure.
2)
Display the Pilot screen on a GPD, watch the rudder indicator
carefully whilst turning the helm slowly from hard-over port to hard-
over starboard. The indicated angle should change smoothly as the
wheel is turned.
If the indicator does not move at all follow the Dockside
Commissioning procedure
If the indicator is erratic move to step (3)
Summary of Contents for H3000 Pilot
Page 1: ...Pilot Handbook www bandg com ...
Page 106: ......
