___________________________________________________H3000 Pilot Handbook
HB-3001-02
15
OPERATING INFORMATION
SWITCHING ON
The H3000 Pilot has two power supplies (instrument and heavy duty
rudder drive supply) these are normally connected via circuit breaker. The
Pilot computer and Pilot displays are powered via the Fastnet network
cable and share the same source of power supply as the H3000 instrument
system.
The hydraulic ram, rotary drive or hydraulic pump supplies are routed via
the Pilot computer. The heavy-duty supply is dedicated to the rudder drive
unit and is connected via a separate heavy-duty fuse or circuit breaker.
To switch the Pilot ON, proceed as follows:
Switch ON the instrument supplies.
Switch ON the heavy-duty power supply for the rudder drive unit.
The Pilot will only operate if both the heavy duty and instrument
supplies are switched ON.
Notes:
If the Pilot Display indicates
Fault 115
when engaged for the first time,
check that the heavy-duty drive supply is switched ON. If it is off switch
ON the heavy-duty supply and clear the fault message.
If the Pilot Display shows
Fault 104
when engaged, this indicates that
there is no boat speed input from the sensor. This is normal if the Pilot is
switched on at the dockside.
Summary of Contents for H3000 Pilot
Page 1: ...Pilot Handbook www bandg com ...
Page 106: ......