Aztech NETCARD AZ-NC2100, User Manual

Page: 10 / 49

10
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Chapter 3 — Setting Up the Network Card
3.2 Connecting the Network Card
For 10Mbps connection, you may use Category 3, 4, or 5 UTP Ethernet cable.
For 100Mbps connection, use only Category 5 UTP Ethernet cable.
This completes the setting up of your network card. Please proceed to the next
chapter to install your network card driver.
For descriptions on the LEDs, you may refer to the section on LEDs Descriptions.
Do not plug in your telephone line to the Ethernet Jack! The Ethernet
Jack is only for the network cable.
Ethernet Jack
either connect the
Ethernet cable to
another
†
computer that
has a PCI network card
or
connect it directly to a
Hub
† For connection between 2 computers, a
crossover UTP cable must be used.
Link LED
Activity LED
100M LED