Axis AXIS StorPoint CD, User Manual

Page: 50 / 135

Section 4: Setting Up - NetWare
AXIS StorPoint CD User’s Manual 49
Alternatively, if you have a Time Provider Group on your system you
can provide a list of servers for the StorPoint to contact to obtain its
time synchronization. The list can also contain Secondary Time
Servers. The list of servers is inserted into the
TimeSyncSources
parameter as follows:
TimeSyncSources = server1,server2,server3,....
NetWare/IP
To use the IP protocol in NetWare, you must set the Internet address.
If you use DHCP, the DHCP manager will set the default router
address and the subnet mask automatically. See instructions in “
Setup
for TCP/IP ” on page 20.
Follow these steps to set up the communication:
1. From Windows Explorer or File Manager, locate the
configuration file at
AXIS<nnnnnn>\config\config.ini
, where
<nnnnnn>
are the last six digits of the serial number. Alternatively,
use the AXIS WinPoint Windows tool or a Web browser to set
the parameters.
2. Open
config.ini
with a text editor and enter the appropriate
settings for the following parameters:
3.
Reboot the StorPoint CD and wait 5 minutes. Clients that support
the NetWare/IP protocol will now connect directly to the StorPoint
CD, i.e. peer-to-peer. Clients without NetWare/IP support will be
routed through a Novell server with an IPX/IP gateway.
Parameter name Value Description
[IP]
PrimaryDNS = The Internet address of the primary DNS server.
Used for identifying computers with names instead of
IP addresses.
SecondaryDNS = The Internet address of the secondary DNS server,
should the primary DNS server be unavailable or
disconnected.
[NetWare]
NetWareIP_Enable = yes Enables NetWare over the IP protocol.
NetWareIP_DSS_Server = The host name or Internet address of the DSS
server.