AXIS 5570e Installation Guide
Page 17
EN
GLISH
Note for IPDS printing:
2.
Click the
Configuration Wizard for IBM sessions
button.
3.
Click the
Add Session
button. This will start the
Configuration Wizard
which is a step-by-step guide through
the required configuration settings.
Verifying the Communication Link (AS/400)
Follow the instructions below to verify the communication to the AXIS 5570e:
1.
Type
WRKCFGSTS *DEV AXISPR1
on the AS/400 command line and press
Enter
. The previously created
printer device will be displayed. The status of the printer device should be
VARIED OFF
.
2.
Vary on the printer device by typing
1
in the
Opt
field. Press
Enter
.
3.
Press
F5
to refresh the display. The printer device should now be
VARIED ON
.
4.
Start the printer writer by typing
STRPRTWTR AXISPR1
on the AS/400 command line. Press
Enter
.
5.
Press
F5
to refresh the display. The printer device should now be
ACTIVE/WRITER
.
6.
Direct a printout to this printer device. A successful printout verifies the communication link between the
AS/400 and the AXIS 5570e.
Note:
Proceed to
Print Server Management and Configuration
for information on supported management and
configuration tools.
In the Configuration Wizard, you can choose between PCL or PostScript printing. Choose the printer lan-
guage that corresponds to your printer.
If the setup fails, please refer to the troubleshooting section in the AXIS 5570e User’s Manual, on
www.axis.com
Summary of Contents for 5570e
Page 1: ...ENGLISH FRANCAIS DEUTSCH ESPAÑOL ITALIANO AXIS 5570e Network Print Server Installation Guide ...
Page 146: ......
Page 181: ......
