Axis 14363, User Manual

Page: 53 / 95

Section 5: Configuration Parameters
AXIS AFP IOP User’s Manual 49
Interface Release
Time Out
Interface Release Time Out............................... [IOP Release Time-Out]
Note: This option is only used on the Optra and 4039 Plus series of printers.
On non- Plus 4039 printers use the printer option [Print Timeout].
Refer to the Lexmark User manuals for more information.
The Release Timeout options control how long time must pass after the
interface has used the IOP port until the other input ports (serial or
parallel) can be used on the printer.
This time must be set large enough to ensure that for example an IPDS
job can be printed without pages from the parallel or serial ports being
inserted between the IPDS pages.
If a partial non-IPDS Coax page exists in the printer buffer, this page will
be printed and the timer will be restarted before exit from IOP mode. This
option has higher priority than option C28 Coax Time Out.
The normal printer FF-timeout controls the time for switching to IOP
mode. The range is from 15-255 seconds.
IPDS Parser syntax (with default setting):
PORT_TIMEOUT = 0;
Error Beep Control Error Beep Control ................................................. [Error Beep Control]
This option can be enabled to detect different kinds of errors. The beep
pattern is always 6 beeps consisting of short and long beeps.
Please note, disabling only affects beeping on software errors. Hardware
error signaling can not be disabled. In case of hardware error signals refer
to Appendix F - Customer Support.
IPDS Parser syntax (with default setting):
ERROR_BEEP = 0;
• 30 [15..255] Interface Time Out in seconds
• 0 [No] No beep.
1 [On] Burst of 6 beeps on user errors.
2 [Continous] Beep while error persists.