Axis 14363, User Manual

Page: 21 / 95

Section 3: Utility Program Operation
AXIS AFP IOP User’s Manual 17
Making Changes to Config File Options
In the Main Menu, press <Alt> C to select menu [Config file] and move
down with the arrow keys to select between [Coax options], [Twinax
options], [Printer options], [Serial options] and [IPDS options].
As an example [Printer options] is selected. To change the number of
input trays press the arrow down key to [number of cassettes]. Press
<TAB> and the zero in [Option values] will highlight. Change value to
two, and press <TAB> again. The [Accept] field is now highlighted. Press
<ENTER> and the above screen is displayed, or press <TAB> if other
printer options must be changed. Follow the same procedure to change
other options.
Note: If this utility program option window is closed by pressing <ESC>, Cancel
or clicking on the upper left window close square, the changes made to the
config data will be lost.
It is possible to change only a single option on the AFP IOP and then
download the option directly from the option screen by pushing
[Download Option]. The word Downloading will flash a couple of times
in the lower right corner of the screen until the download is completed.
Important In order to download or upload, make sure the Lexmark printer has been
set into remote setup mode by pressing the two [OK] buttons in the
[Remote Setup] menu in the IOP front panel menu. Alternatively the
download sequence in the utility program can be activated before the
printer is powered ON. This way the interface will detect the data at its
serial port as the first step in the power ON routine, and only run in
upgrade mode. Note that the printer will display an error message after a
while as the interface only communicates with the serial port and not with
the IOP port. This does not affect the download.