Innovator CU10BT-CU5000BT Analog Transmitter
Initial On Site
Turn On Procedure
Instruction Manual, Rev. 0
35
Table 11.3: Analog Modulator Main Set Up Menu Screen
This is the Transmitter Set Up Analog Modulator Main Sub Screen. Push the
ENTER button to access the Set Up Analog Modulator Set Up submenu. Push
the DOWN Arrow to view the next Set Up Main Sub Screen, which is the Set Up
Menu Upconverter Main Sub Screen
Table 11.3.1: Analog Modulator Selected System Plan Set Up Screen
This screen sets up the Television System of operation.
Table 11.4: Upconverter Main Set Up Menu Screen
This is the System Set Up Upconverter Main Sub Screen. Push the ENTER
button to access the Set Up Upconverter submenus. Push the LEFT Arrow to go
back the Main System Set Up Screen.
NOTE:
Refer to the description in Table
11B for how to change the values on the following set-up screens.
Table 11.4.1: Upconverter Channel Type Selection Screen
One of the above screens is displayed as the first screen on entering the
upconverter set up screens. It will indicate the Channel Type currently
selected. The display will not be blinking. Pushing the Down Button will
display the Upconverter Channel Selection Screen.
NOTES:
The
Upconverter transmit channel type should not be changed, unless the
transmitter is being converted from one channel to another. The SETUP 1
or SETUP 2 selection is controlled by a Low, ground, for SETUP 2 or a High,
open, for SETUP 1 at J12-7, on the Remote Interface Jack J12 located on
the rear panel of the Exciter/Driver Drawer. Changes should only be made
while the transmitter is in standby. Contact Axcera Field Service before
using this menu.
With a Channel or Custom Frequency screen displayed, the Channel type
can be set to the American Channel, European Channel, Custom UHF
Frequency or Custom VHF Frequency by first pushing the enter button. This
will cause the channel type to blink. Pushing the Up or Down Arrow Key will
display each Channel type screen in sequence. When the desired screen is
displayed pushing the Enter Button will cause the display to become steady.
This displayed channel type is now used in the following screen to configure
the Upconverter PLL circuits.
Table 11.4.2: Transmit/Upconverter Channel Selection Set Up Screen
The above screen is displayed when the Down Arrow is pushed at the
channel type selection screen. It will indicate the Channel currently
selected and the center frequency of the selected channel. The display will
not be blinking. Pushing the Down Button will display the Upconverter IF
Frequency Selection Screen.
NOTES:
The Upconverter transmit channel
should not be changed, unless the transmitter is being converted from one
channel to another. Changes should only be made while the transmitter is
in standby. Contact Axcera Field Service before using this menu.
Summary of Contents for Innovator CU10BT/CU0T-1
Page 72: ......
