AWH TANKO CP Series, Operating & Installation Instructions Manual, Page: 48 / 86

TANKO®-CP Jet Cleaner
40/77
Translation of the original operating/installation instructions 2016/10 6 Commissioning
WARNING
Risk of burns from hot surfaces!
The device may heat up significantly as a result of the cleaning fluid or the heat transfer
from the container. Contact with the device can cause burns on the skin.
There is a risk of death or severe physical injuries.
 Comply with the warning signs and DO NOT touch the indicated areas.
 Do NOT remove insulation from protected hot surfaces.
 Maintain safety clearance of existing protective equipment or barriers.

Use protective equipment (e.g. protective gloves; cloths) to provide protection from the
hot surface.
 Do not touch the device until after a sufficient cooling time.
When operating the device, adhere to the following additional instructions:
WARNING
Persons in the container. A person may be struck by the jets from the cleaning head!
There is a risk of death or severe physical injuries.
 DO NOT start cleaning operation while there are persons in the container.
 NEVER direct the cleaning jet or torrent at persons.
WARNING
Incorrect operation of the device!
There is a risk of death or severe physical injuries.
 Only operate the device when it is in perfect condition.

Do not operate the device unless it is installed inside an enclosed container.
 Drain and depressurize the container being cleaned.

Close all of the openings on the container (e.g. inspection openings).
 When operating the device, adhere to the switch-on and switch-off procedures
(see
sections 6.3 Switch-on procedure and 7.2 Switch-off Procedure ).
 There is no need for the device to be run in.
 The following operating states of the device are NOT permitted:
–
Operation of the device without cleaning agent.
–
Immerse the device in the product of the production process.
–
Operation of the device outside the permitted parameters
(see
section 3.3 Technical data ).

Immediately stop operation in the event of leaks outside the container.
 Refrain from any type of work which compromises the safe and reliable function of the device.

Immediately inform the operating company of any changes to the device or the plant that may impair
its safety.