AVTECH Inc.
5
TemPageR 3E
Installation
NOTE: If there are multiple Ethernet adapters on the computer that the AVTECH Device Discovery Utility is installed on, a
dialog will display asking for the proper network to perform the search on. Make the correct selection and then continue.
The TemPageR 3E unit is initially set to obtain an IP address automatically using DHCP. If you do not
have DHCP on your network, please see the ‘Static-Only Networks’ section below.
The TemPageR 3E unit connected to your network should appear in the AVTECH Device Discovery Utility
window as illustrated above. This will normally take just a few seconds. If the IP address displayed is ‘169.
xxx.xxx.xxx’ and the ‘Name’ is displayed as ‘Unknown’ or if the TemPageR 3E unit was not found, please
see the ‘Device Not Found Or Invalid IP Address’ subsection below before continuing.
Once the TemPageR 3E unit is displayed, select it from the list to perform an action on it. Selecting multiple
units will cause the action selected to be performed on multiple units (i.e. all selected units) simultaneously.
The
‘Set IP’
button is used to assign a static IP address, gateway IP address, subnet
mask and DNS server IP address or to set the TemPageR 3E unit back to DHCP
(0.0.0.0). If the ‘Set IP’ button is pressed without a specific TemPageR 3E unit selected
in the AVTECH Device Discovery Utility, a prompt will display asking for the MAC address of the unit.
This option can be used in conjunction with the MAC address listed on the bottom of the TemPageR 3E
unit to attempt IP address assignment of a unit that cannot be located or has previously been obtained or
assigned an incorrect IP address.
The
‘Settings’
button opens the default web browser and displays the ‘Settings’ screen of the
TemPageR 3E web interface. The ‘Settings’ screen allows for further configuration of the
TemPageR 3E unit and is where alerts, email, SNMP and other settings are configured.
The
‘Web’
button displays the main ‘Status’ screen of the TemPageR 3E web interface which
shows current sensor data and alarm status in the default web browser for the system you are
using. Be sure to bookmark the link that loads for quick and easy reference in the future.