SPECIALIZED TEST JIGS
AVX-TRR-ANB, AXIAL NO-BEND JIG
The AVX-TRR-ANB test jig accepts two types of packages:
●
DO-41 (0.205" x 0.107" body, maximum)
●
Microsemi Axial Type E (0.185" x 0.135" body, maximum)
The DUT is installed in the test jig by dropping it over the area marked “DUT” on the
test jig PCB. Four “fins” guide the DUT into the correct position between two spring-
loaded test pins. When the hinged lid is closed, a fifth “fin” attached to the underside of
the lid presses the DUT against the spring-loaded pins, to ensure good electrical
contact. A DUT is shown in position in the photo below (with the lid open):
42
Cathode Spring Pin
Anode Spring Pin
Guide Fins (4)
Lid
Closure
Safety
Sensors
Lid
Pressure
Fin
Lid Closure
Magnet
Summary of Contents for AVR-EB4-B
Page 69: ...PCB 158R5 LOW VOLTAGE POWER SUPPLY...
Page 71: ...PCB 104G KEYPAD DISPLAY BOARD...
Page 76: ...TEST JIG WIRING AVX TRR HPOST...
Page 83: ...PERFORMANCE CHECK SHEET 83...
