Avocent AV Works, Installer/User Manual

Page: 103 / 144

Chapter 7: CCM AMP 91
Managing User Sessions
The Status tab displays information about currently active Telnet sessions. Each line of session
information includes:
•
The name of the user who is logged in to the session.
• The length of time this session has been active, in the form hours:minutes:seconds. If the ses-
sion has been active for more than 24 hours, the number of days precedes the other time infor-
mation. For example, a session that has been active for two days, three hours, seven minutes
and 52 seconds will show 2d 3:07:52.
• The name of the device to which this session is connected.
• The IP address of the connected client.
To disconnect a user session:
1. Click the Status tab in the CCM AMP.
2. Select one or more sessions to disconnect. Press the
Shift
key to select multiple sessions.
3. Click the Disconnect Session button. A message prompts you to confirm the disconnect request.
4. Click Yes to disconnect the user(s).
-or-
Click
No to cancel the disconnect.
Viewing and Changing Serial Port Parameters
The Ports category lists all configuration parameters for the CCM appliance ports. You may change
any port parameter except the name and type.
To modify a port:
1. Click the Settings tab in the CCM AMP.
2. Select the Port s category.
3. Select a port and click the Modify button. The Modify Port dialog box appears.
4. To change the session time-out, enter a value in the Session Timeout field in the range 1-90.
-or-
Choose a value from the pull-down menu. If you choose
Global Setting , the value specified in
Global - Sessions will be used.
5. To change the CLI access character, enter a caret (^) and a character in the CLI Access Charac-
ter field. The character entered after the caret may be a letter or one of the following: left
bracket ([), right bracket (]), caret (^), underscore (_) or backslash (\). To change the CLI
access character, enter a single character in the CLI Access Character field.
-or-
Choose a value from the pull-down menu. If you choose
Global Setting , the value specified in
Global - CLI will be used.