Latest products and information available at www.avlite.com
13
AV-426-ICAO
Radio Controlled Solar Aviation Light
The encryption key can be re-entered into the new controller without the need to
reprogram all the lights in the Radio Control System.
Encryption key cannot be 00000000000000000000
Press [SEND] to save the Radio Control System settings
Note:
Failure to select appropriate settings and save the settings will result in the Radio Control
System not being appropriately optioned.
Congratulations you have now set up your Radio Control System. Please continue to the next
section to setup each light in the system.
Section 2
Programming the light using the cable interface and hand held controller
NOTE: In this programming mode it is necessary to press send to save each option as each
option is selected in the sub menu, before moving to the next sub menu item. Failure to press
send before moving to the next menu item will result in selections not being saved.
1.
The programming port is located under the light head. It is necessary to remove the light head to
access this programming port.
2.
Ensure that the light is turned off at the master switch on the control panel at the base of the solar
unit
3.
Remove the 4 socket head cap screws and remove the light head from the solar unit enough to
access the programming port. The light needs to remain connected the solar unit. Remove the
blue waterproof cap from the programming port.
4.
Connect the programming cable to the light head.
5.
Connect the programming cable to the programming/charging port located on the left hand side of
the ALS2.4GHz handheld radio controller.
6.
Turn on the controller at the Red Master switch located on the right hand side of the ALS 2.4 GHz
handheld radio controller.
Programming Port
Replace blue cap after
programming
