EX5000 Release 8.2.2 Installation Manual
- 32 -
•
Engine Instruments Setup.
•
Lightning, Traffic, GPS, and MAP parameters, described in this section.
Refer to the applicable software update service bulletin for appropriate configuration save and restore
utility availability and use instructions.
5.4 Using the Maintenance Mode Page
The MFD Maintenance Mode Page contains the setup pages for each function.
To start using the Maintenance Mode Page, apply power to all the sensors that interface with the
MFD, including the GPS, the Lightning and Traffic sensors, Engine interface unit, ADS-B receiver,
and TAWS sensor.
5.4.1 Entering Maintenance Mode
To access Maintenance Mode, press the buttons from the Aux or Setup Page as follows:
1.
Turn on the MFD by applying power to the aircraft
The system will begin its normal start up sequence
2.
At the prompt, “Press any bezel key to continue”, press any button.
3.
Rotate the left knob clockwise until the Aux or Setup Page displays.
4.
Simultaneously press and hold buttons L1 (top left) and L3 (3rd down on the left) (Figure 6:
EX5000 Landscape Front View) for at least 5 seconds.
The Maintenance Mode Page displays. Note that the available setup options depend on the
specific aircraft.
Figure 7: Example Maintenance Mode Page
5.4.2 Working in Maintenance Mode
As shown in Figure 7: Example Maintenance Mode Page, the Maintenance Mode Page contains
setup buttons for the available EX5000 features. When you select a Setup feature, the appropriate
page displays. From the Setup page, the following options will always be available:
