EN
12
C - INSTALLATION
•
The height of the centre of the mounting bracket must be the same as the centre of the gate frame on
which the actuator is mounted.
D
B
post
B
31mm
D
(mm)
B
(mm) max angle (°)
0
180
120°
10
180
120°
20
170
110°
30
170
110°
40
160
100°
50
160
100°
60
160
100°
70
155
95°
80
155
95°
90
155
95°
100
150
95°
110
145
95°
120
140
90°
130
130
90°
140
130
90°
150
125
90°
Mark the location of the holes in the post, ensuring that the post mounting bracket is mounted horizontally
at the end. Use 10-inch lag screws or any other fastening system suitable for the post material.
Please note: there will be significant force on the mounting bracket when the motor drive is running.
We recommend sealing threaded rods at least 15 cm in length. If the post is made of metal, we
recommend welding or passing the threaded rods through to secure them with self-locking nuts.
Consult a professional if in doubt.
Turn the actuator over and make sure the carriage rod is about 5 mm from the opposite end of the
motor. Otherwise, move the carriage using a 9V LR61 battery. The motors can also be connected to the
electronic card (see connection section) and manual mode can be started in order to power the motors
while adjusting the position of the carriage.
Please note: It is very important to follow this step otherwise the gate may not fully open or close
properly!
CONNECTED MOTOR DRIVE KIT WITH ACTUATORS
