Avid Technology Pro Tools S6 Master Post Module, Installation Manual

Page: 25 / 92

Chapter 3: Assembling Legs 17
Attaching the End Brackets
To attach the End Brackets:

Using eight fasteners and washers per bracket, attach the Left and Right End Brackets to the Legs as shown in Figure 6. Do not
tighten the fasteners fully.
If Your System Includes a Leg Frame Join Option
The Leg Frame Join option lets you join two or more S6 Leg Frames together to form a larger system. If your system includes a
Leg Frame Join module, refer to the documentation included with it. to install its special center legs and brackets.
If Your System Includes a Leg Frame Extension
The Leg Frame Extension option lets you add a chassis to the left and/or right end of a Leg Frame. If your system includes a Leg
Frame Extension, refer to its included documentation to install it.
Leveling the Leg Frame
To level the Leg Frame:
1
Start at the back of the frame (either end) and make sure the back beam sits flat on top of the Leg as shown in Figure 3.
2
Starting at either end, place a level (not included) on the top of the leg between the beams, or across both beams directly above
the Leg as shown in Figure 7, and determine whether you need to raise or lower the back or front of the leg.
Figure 6. Attaching the right side End Bracket (left side End Bracket shown attached)
Figure 7. Side view of a level placed across front and back beams above the left leg
(Not to scale)
M5x15 (7760-30604-00)
Fastener
M5 WSHR (7760-30607-00)
Washer
M4 Hex
Tool