Avid Technology Pro Tools S6 Master Post Module, Installation Manual

Page: 51 / 92

Chapter 5: Installing Power and Connectivity 43
3
Run the Cable Set through the (lower) triangular cable guides in the Rear Cover brackets to the furthest (left- or right-most) chas-
sis, as shown in Figure 21. (For systems with more than three chassis, see “Installing Cable Sets in Large Configurations” on
page 44.)
4
Connect the other ends (1–5) to the Ethernet terminal ports (1–5) on the outside back of the chassis.
5
Repeat for other Cable Sets and chassis (except the chassis containing any Ethernet switches) as shown in Figure 22:
• Connect cables 1–5 of the next set to the Ethernet switch.
• Run the cable set through the triangular cable guides in the Rear Cover brackets to the next chassis.
• Connect the Cable Set cables 1–5 to the Ethernet terminal ports 1–5 on each chassis.
6
For the chassis containing the Ethernet switch(es), use the Small Cable Set and connect cables 1–5 to available ports on the
Ethernet switch, and connect the other ends to terminal ports 1–5 on the chassis.
The recommended order for Cable Sets is to start with the furthest chassis (either far left or far right) from the switch using one
of the longest Cable Sets. Then work across the frame, connecting the switch to the next channel chassis (to the left or right of the
first chassis you connected) and repeat for every chassis except the master section chassis, which should be connected last.
Figure 21. Connecting the first Cable Set to the first (left-most) chassis Ethernet terminal ports
Figure 22. Connecting the next Cable Set to the right-most chassis Ethernet terminal ports
Figure 23. Connecting a Cable Set Small to the Ethernet terminal ports on the back of the switch chassis
1 2 3 4 5
1 2 3 4 5 1 2 3 4 5
1 2 3 4 5
1 2 3 4 5
1 2 3 4 5 1 2 3 4 5
1 2 3 4 5
1 2 3 4 5 1 2 3 4 5 1 2 3 4 5