AVGear AVG-UHMS88, User Manual

Page: 8 / 31

AVG-UHMS88
3.2 Rear Panel
No. Name
Description
INPUTS
a. IR OUT: 8 in total, connect with IR emitters to deliver the IR signal sent from
the far-end receivers connected to the HDBaseT ports.
These IR OUT sockets make up an IR matrix with the IR IN sockets on the far-
end receivers, and all can be switched synchronously with the AV signal, or
switched separately.
Default setting, the 8 IR OUT corresponds with the 8 IR IN, i.e. IR OUT1
→
IR
IN1, IR OUT2
→
IR IN2,
…
IR OUT8
→
IR IN8.
b. AUDIO: Auxiliary audio input ports, 8 in total, connect with PCM audio sources
c. HDMI: HDMI input ports, 8 in total, type A female HDMI connector, connect
with HDMI input source devices.
OUTPUTS
d. IR IN: Connect with IR carrier (with receiver), 8 in total, correspond to the 8 IR
OUT, cannot be switched separately. It makes up an IR bi-directional
transmission with the IR OUT on the corresponding far-end receiver.
e. RS232: 3-pin pluggable terminal blocks, 8 in total, correspond to 8 output
sources separately, communicate with the RS232 port on corresponding
HDBaseT receiver, cannot be switched separately. When controlled by
HDBaseT receiver, the communication protocol must be the same with the
AVG-UHMS88’s.
f. AUDIO: stereo audio output ports, 8 in total
g. HDMI: Local HDMI output ports for HDMI Inputs 1~4, synchronously switched
with HDBaseT Outputs 1~4
h. HDBaseT: output extension ports, works with HDBaseT receivers to extend
signals and power far-end HDBeseT receiver over a single CAT5e/6 cable.
③
RS232
Serial port for unit control, 9-pin female connector, connects with control device such
as a PC.
④
IR ALL IN
Input port for IR control signal, connect with IR receiver (with carrier), delivers the
received IR signal to all the 8 far-end receivers.
⑤
TCP/IP TCP/IP port for unit control
⑥
IR EYE Connect with extended IR receiver, use the IR remote to control the AVG-UHMS88.
⑦
Power Trigger Press the button to turn on/off the matrix. Indicates red when power on.
⑧
Power port Connect to an AC 100V~240V power adapter via the included power cord.
⑨
GROUND Connect to ground to earth the chassis.