11-4
System Administrator’s Guide
U s i n g t h e N e t w o r k C o n s o l e P a c k e t
If you cannot connect the printer to your network using MonarchNet2 (or similar
networking tool), try using a wired connection to configure the network printer. If that
does not work, send console commands to the printer instead. The network console
packet is written in MPCL and accepted through the printer’s serial port.
Syntax
{N,number,action,device,"name" |
C,"con_comds" | }
N1. N
Network Console Packet.
N2. number
Number from
0
to
999
to identify the network console
packet.
1
is the default.
N3. action
Action. Enter
A
to add a network console packet.
N4. device
Storage device. Enter
T
to pass the packet through the
printer and store the packet in the wireless module.
N5. “name”
Packet name,
0
to
8
characters, enclose within quotation
marks.
“”
is the default.
C1. C
Command field.
C2. “con_comds”
Console commands. Must be enclosed within quotation
marks.
“”
is the default. Each command must be on a
separate line. The maximum number of characters per
command is 100. Refer to the complete list of console
commands in the
ADTP1 MonarchNet2 Operating
Instructions
for more information.
Note:
The maximum number of commands per packet is twenty
five (25).
IP Address Example
{N,1,A,T,"protocol" |
Names the packet
protocol
C,"set ip me static" |
Sets method to obtain IP address as static
C,"set ip bot 5" |
Sets boot retries to 5
C,"set ip add 192.0.0.192" |
Sets IP address to
192.0.0.192
C,"set ip sub 255.255.0.0" |
Sets Subnet Mask to
255.255.0.0
C,"set ip ro 192.1.1.192" |
Sets IP Gateway to
192.1.1.192
C,"init" |
Saves the settings and initializes the printer
C,"exit" | }
Exits console mode
Summary of Contents for Monarch Tabletop Printer 1
