Avery Dennison Monarch Tabletop Printer 1, System Administrator Manual

Page: 37 / 94

Setting Wireless Communications 5-3
R o a m T h r e s h o l d
Sets the roaming threshold. Whenever the printer’s signal strength gets below this value,
the printer connects to another access point in range with better signal strength. This
prevents excessive roaming between access points if the printer is located near two
access points.
The range is 1-15. 1 gives no preference to the currently connected access point.
15 gives the maximum preference to the currently connected access point.
Select To
1 - 3 Sets the roam threshold to 11 decibels. When the printer’s signal strength
gets below 11 decibels, it connects to another access point in range with
better signal strength.
4 - 6 Sets the roam threshold to 12 decibels.
7 - 10 Sets the roam threshold to 13 decibels.
11 - 13 Sets the roam threshold to 14 decibels.
14 - 15 Sets the roam threshold to 15 decibels.
Note: This setting is helpful when the printer is on a Mobile Workstation.
T r a n s m i t R a t e ( A d - H o c O n l y )
The transmit rate sets the maximum speed at which the devices communicate with each
other on the network. The speeds are in Mbps (megabits per second). The transmit rate
is negotiated with the access point and this setting may be ignored. Use this setting in
ad-hoc mode only.
Select To
1 Communicates at 1 Mbps.
2 Communicates at 2 Mbps.
5.5 Communicates at 5.5 Mbps.
11 Communicates at 11 Mbps.
12 Communicates at 12 Mbps.
18 Communicates at 18 Mbps.
24 Communicates at 24 Mbps.
36 Communicates at 36 Mbps.
48 Communicates at 48 Mbps.
54 Communicates at 54 Mbps.