8-10
System Administrator’s Guide
Setting the Start Encode Position
This option only appears in the Advanced Setup menu. The start encode position is
only
used in non-stop encode mode
. The printer uses this initial starting position to look for
the RFID inlay to program while moving the supply. The range is 10 to 2000. The default
is 0.
The start encode position is measured from the leading edge of the supply to the
beginning of the RFID inlay encoding area in 0.01 inches.
The start encode position must “lead” (be before) the first TID position; otherwise, error
737 occurs.
Use the
RFID Printer Setup Utility
to determine the start encode position then enter the
value at the printer.
Select To
Decrease the setting.
Increase the setting.
Note:
Press the left function button to change the amount (by 1, 10, or 100).
S t ar t E n c o de P o s it i o n
T r a il i ng E d g e
0 , 0 p o i n t
L e a d i n g E dge
Summary of Contents for Monarch Tabletop Printer 1
