1.
Unpack MLT-PROWALL-4K and connected with 12V DC power supply unit.
2.
Check User
Guide from page 10 to 17 to select the display mode # as you need. Please pay attention to the Bezel
Correction setting in page 10.
3.
Set Display Mode dip SW based on the modes #. If the No. is 125, it means the dip SW pin 1, 2 & 5 should be set at ON
(up) position. All the rest is still at OFF (down) position.
4.
Install the LCD display and connect with MLT-PROWALL-4K as showed in UM with correct position, angle and direction.
5.
Select input port and set EDID to get optimized input resolution. Please see more details in page 19 & 49.
6.
Power on signal source, MLT-PROWALL-4Kand LCD, then you will see the result.
7.
If no input signal, it will automatically power off after 60 seconds. Once the input signal appears again, the system
will power on automatically.
8.
If you want to set bezel compensation, please see page 10.
9.
If you want to add PIP or display dual contents on the video wall, please enable PIP/POP mode.
10. If any change is required in Dip SW, please turn system OFF & ON again to get new setting.
11. Please check output LED indicators and make sure all output LED is ON.
12. Please note that poor cable or long distance connection may cause dot noise.
MLT-PROWALL-4K Advanced applications
using
remote controller
1.
If MLT-PROWALL-4K is installed at a location that can’t be directly accessed by remote control, please connect
IR Extender and set IR receiver at a position that can be accessed by IR remote control.
2.
Turn all Dip SW pins in [Main Input] to OFF position to switch the authority of the system control to OSD setting. If any
[Main Input] Dip SW is turned to ON position, MLT-PROWALL will follow the command from Dip SW settings but not
the settings from OSD menu.
3.
I
f no input signal, the system will automatically power off after 60 seconds. You can set [Standby Time Out] to “0” to keep MLT-
PROWALL-4K in power on status even no input signal. Once you had selected an input port and input signal has been detected, MLT-
PROWALL-4Kwill wake up and send out the signal to LCD automatically.
4.
Before you select specific display mode from OSD menu, please check Display Mode list. You also need to familiar
with OSD operation. After selecting display mode, the OSD will be also split into different sections.
5.
Open OSD and navigate to [Video Wall] menu. You will find the icons for all display modes with the display mode
number at the bottom position. Please click on it to select the display mode you need.
6.
For cascade and advanced operations, please see more details in User Manual. When you operate [Video Wall]
menu, it may have frame tear in the display. It will disappear after you power OFF/On the system.
7.
After finishing OSD operation, please save the result in [Profile] menu. When you turn OFF/ON the system again, it
will remain the same setting without change.
8.
If any of the [Main Input] Dip SW has been turned to ON position, the system will take Dip SW setting as first priority
and user needs to load [Profile] settings to show the setting from OSD menu operations.
IMPORTANT NOTES
VI
www.av
enview.com
