Avaya Secure Router 2330, Hardware Installation

Page: 38 / 126

Table 21: Module LEDs
LED Description
LINK/STAT Status of interface:
• Off: Not connected or the interface is out of service
• Yellow: The interface is in a loopback mode or is running diagnostics
• Green: The link or channel is active and receiving a valid signal
STAT General module status:
• Off: No power available to the module
• Yellow: Out of service, or failed to initiate
• Green: Power on and the module is operational
GbE Medium Module (supported on Secure Router 4134 only)
The 10-port 10/100/1000 Ethernet Advanced L2/L3 Medium Module provides ten
autonegotiating 10/100/1000 Mbps copper Ethernet ports and two SFP Gigabit Ethernet ports
(full duplex). Up to ten ports can be in use at one time. The module is non-blocking. The 10-
port GbE Medium Module provides both Layer 2 switching and Layer 3 routing functionality.
You can use copper port 5 or fiber port 5—you cannot use both simultaneously (the same is
true for copper port 10 and fiber port 10). If a copper cable and a fiber cable are connected to
the same port (port 5, for example), the module uses the first active link. If you disconnect the
active link, the module automatically switches to the remaining connection.
The following figure shows the 10-port GbE Medium Module.
Figure 18: 10-port GbE Medium Module
Table 22: Cable and connectors
Port Connector Recommended
cable type
Minimum cable
length
Maximum cable
length
10Base-T (full-
or half-duplex),
100Base-TX RJ45 EIA Category 3,
4, or 5 UTP for
10 Mb/s None 328 ft (100 m)
Avaya Secure Router 2330/4134 hardware components fundamentals
38 Installation — Hardware Components August 2013
Comments? infodev@avaya.com