Avanti OCTOPUS XL120, User Manual

Page: 26 / 36

2 3
CAUTION
When the UP or DOWN button is pressed on
the external control box in the cabin, the response of
the cabin is delayed. During this delay, an acoustic
signal will sound
and the warning lights (if installed)
are flashing . This way, any personnel in the
surroundings are warned of the imminent movement
of the service lift.
WARNING
Before closing the lift door, ensure that your
equipment (i.e. lanyards) is not trapped or tangled with
the closing door and / or with surrounding elements.
WARNING
To prevent the lanyards from tangling with surrounding
elements, keep them properly attached to your body
harness.
WARNING
To prevent the lanyards from tangling with the moving
service lift, do not get close to the hoistway.
1.
Close the cabin door and the platform fence door.
2.
Push and hold the UP or DOWN button in the platform
control box to ascend or descend the cabin.
3.
Then platform light (green) illuminates, cabin is
aligned with a platform and can be opened.
When the fence doors feature a trapped-key system:
1.
Close and lock the platform fence door.
2.
Turn the trapped-key switch to ON in Main control box,
and close the cabin door.
3.
Push and hold the UP or DOWN button in the platform
control box to ascend or descend the cabin.
4.
Then platform light (green) illuminates, cabin is
aligned with a platform and can be opened.
4.3. 7 Operation from platforms ( Call or Send and
Call function )
When the fence doors feature a guard locking system:
CAUTION
When the UP or DOWN button is pressed on the
platform control box, the response of the cabin is
delayed. During this delay, an acoustic signal will
sound and the warning lights (if installed) are flashing.
This way, any personnel in the surroundings are
warned of the imminent movement of the service lift.
WARNING
Before closing the lift door, ensure that your
equipment (i.e. lanyards) is not trapped or tangled with
the closing door and / or with surrounding elements.
WARNING
To prevent the lanyards from tangling with surrounding
elements, keep them properly attached to your body
harness.
WARNING
To prevent the lanyards from tangling with the moving
service lift, do not get close to the hoistway.
4.3. 8 Overload detection device
An overload detection device is built into the traction
hoist. In case of an overload, it will prevent the upward
travel of the service lift (by interrupting control) and a
buzzer will sound, until the overload condition is
eliminated.
WARNING
When entering and starting the lift, the buzzer may
sound briefly. This is due to temporary load peaks that
occur when the lift starts to ascend. The control box is
designed to not activate the buzzer or stop the lift due
to these load peaks caused by the swaying of the
cabin.
DANGER
The service lift must not be used if it is overloaded
DANGER
It is forbidden to carry out a manual descent in the
event of service lift overload.
NOTICE
Only a Certified technician may adjust the overload
limiter (Refer to “Adjustment of the of overload
detection device” Appendix in Installation and
Maintenance Manual).