AVANT 225, Operator'S Manual, Page: 59 / 84

Avant 220/225
59
.
Installing of service support and frame
lock
Installing boom service support:
The red service support of the boom lift cylinder is
stored under the boom.
Make sure that the boom stays up during
maintenance operations by putting the service
support on the lift cylinder piston rod. Secure the
service support by locking it on the piston rod with a
long screw or pin.
Service support stored under the boom
Service support in place
Frame lock:
A red frame lock bar is stored near the drive pedals.
This lock bar is intended to lock the articulated frame
to make the loader frame stay straight during e.g.
lifting or transportation.
The holes for the frame lock bar are on the left side
of the loader, one near the rear left wheel and
another on the front frame, close to the articulation
joint.
1.
Slide the solid end (a) of the bar through a hole
on the rear frame of the loader. Hold the other
end of the bar tilted towards the right side of
the loader.
2.
Turn the holed end of the bar towards the left
side of the loader. The other end end should
remain locked in the hole on the rear frame.
3.
Align the other end of the bar (b) and the
frames by turning the steering wheel, this can
be done without running the engine. Once
aligned, slide the bar and lock with its cotter
pin.