AVANT 225, Operator'S Manual, Page: 46 / 84

Avant 220/225
46
.
Refuelling (220/225)
Check fuel level and fill the tank if necessary. It is
recommended to add fuel before the fuel tank gets
empty and keep the tank full to prevent condensation
of water into the fuel tank.
Do not overfill the fuel tank. Leave room for the fuel
to expand. Leave about 50 mm of empty space
below the filling neck of the fuel tank.
If the tank gets empty, prime the fuel system by
leaving the ignition key to ON position for one minute
to allow fuel pump to cycle and prime system. Turn
key switch OFF. Starting may take a longer time as
the fuel lines fill with fuel.
Risk of fire or explosion - Handle fuel with care
DANGER

Always stop the engine and allow it
to cool before refuelling.

Refuel only in a well ventilated area.

Do not overfill the fuel tank. Leave at
least 50 mm below the neck of the
fuel tank to avoid spilling of fuel.

Avoid spilling fuel when refuelling.
Should this happen, wipe the fuel
away immediately in order to avoid
risk of fire.

Keep fuel away from sources of
ignition. Do not smoke during
refuelling.
Use only clean fuel and take care
when refueling the loader to avoid dirt
and water from entering the fuel tank.
Clean fuel cap and surroundings
before opening the cap. Always store
fuel
properly in an approved
container. Water in fuel can cause
severe damage to engine injection
system.
Check fuel cap for damages and replace if
necessary. A lockable fuel tank cap is also available
from your Avant representative.