DPM3 User Manual, 1st Edition
User Manual - DPM3 Series Panel Meters
20
Brightness
HI
Lo
Display brightness level selection.
Hi:
high brightness
Lo:
low brightness
Display color selection between green, red or amber is possible for both
RUN
and
Pro
modes.
Eco
on off
Allows choosing an operative mode with an up to 45% of ENERGY SAVING*
on:
After a programmable time without pressing any key, display will turn off leaving only the
right decimal point flashing; all functions remain active. Display will be again active after
pressing any key.
oFF:
Deactivates the function.
* Measured at 230V AC power supply, display 100.00, amber colour and with no options.
Input Error
YES:
If Process or Load Cell input signal is lower than the minimum, display
will show “- - - - - “.
No:
Without indication.
Additional Functions
Several functions can be controlled via Key Pad that will produce different actions depending
on the instrument operating mode:
TARE and Reset TARE functions
Three different tare modes are available in the DPM3 and their functions are described below.
The desired tare mode can be selected in the Display Configuration
CndSP
/
ModtA
menu.
tare 1
To configure the meter for Tare 1 mode, select
tArE1
under the
ModtA
menu in Display
Configuration
CndSP
. After saving the Tare 1 mode configuration and returning to
RUN
mode, pressing the
UP
key will store the currently displayed value as the tare value (unless it is
over scaled) and the
TARE
Led will light. From this point the value displayed on the meter is
the net value, i.e., the measured value minus the stored tare value. If a tare value has been stored,
