AUTHOR Alarm Kvant 120, Operating Manual

Page: 14 / 32

14
1. Switch the ignition on without starting the engine.
2. Enter the current PIN-code to authorize. There will
be 2 indication signals.
3. Enter the immobilizer Setup menu (Setup menu
is available within 2 minutes after the PIN-code
entering). For this purpose press any of the buttons
connected to the device and retain it pressed during
10 seconds. The indication LED or buzzer will give a
signal once a second.
4. Press any of the connected buttons twice to enter
the sensitivity control sub-menu (see p. 16). The
indication LED or buzzer will give the quantity of
signals, which corresponds to the value of the
current sensitivity level (from 1 to 5). After that
series of dual signals will be given.
5. Set a new sensitivity level by pressing the button the
required number of times from 1 to 5. The value «1»
corresponds to the switched off sensor, the value of
«2» – to the lowest sensitivity level (response to a
strong speedup), the value of «5» – to the highest
sensitivity level (response to a weak acceleration).
Each pressure will be the confirmed by a single
signal of LED or buzzer.
The record of a new sensitivity level will be
confirmed in 3 seconds after the end of the setting
with the corresponding quantity of signals of LED or
buzzer (from 1 to 5). If the record is not performed,
the LED or buzzer will indicate single signals with
duration of 2 seconds. Turn off the ignition and
repeat the steps 1-4.
6. Turn off the ignition.