10
A different combination of buttons and sequence of
keystrokes is allowed, e.g. if you press the button
#1 twice and press the button #2 once, the system
will save all the clicks in this order. When you have
finished entering the PIN-code, the system will
provide 3 confirmation signals of LED or buzzer,
regardless the number of clicks.
6. Enter the current PIN-code once again. If the codes
are matched the indication signal will be given twice.
The PIN-code will be recorded.
The indication will
shift to quadruple signal, once in 3 seconds. To exit
from the PIN-code setting mode press any button
once. If the indication signal appears only 4 times,
it means that the entered codes do not match.
The
PIN-code will not be recorded.
Repeat the steps 5, 6
to set the PIN-code.
7. Disconnect the red wire from power supply circuit
«+» in order to reboot the device.
8. Connect the red wire to the power supply circuit. If
necessary, connect the grey wire in order to use it as
an analogue button.
ATTENTION!
After you have entered the PIN-code, you
will not be able to enter the PIN-code setting mode
using the grey wire (until all settings are reseted to the
factory settings, page 15).
The procedure of PIN-code setting when KVANT is
connected
to
the «inflow» resistor array
(page 24):
1. Switch off power supply from the device (red wire)
and disconnect car battery supply.
2. Connect the grey wire to the red wire.
3. Apply power +12V on the red and grey wires.
Summary of Contents for Kvant 120
