AUTHOR Alarm Kvant 120, Operating Manual

Page: 11 / 32

11
System will switch into the learning mode, the dual
indication signals of the LED or the buzzer will be
provided once in 3 seconds.
4. Disconnect the grey wire, without removing the
power from the red wire. The indication will shift to
triple signal once in 3 seconds.
5. Enter the PIN-code by pressing the buttons of the
resistor array. Every click shall be followed by an
indication signal of LED or buzzer.
The number of
keystrokes shall be in the range from 2 to 9. The
interval between the keystrokes shall not exceed 2
seconds. There is no difference between long and
short keystrokes. Buttons must be pressed firmly.
The grey wire can be used as an extra button with
the «+»potential. To do this, connect it to the power
supply circuit, apply power («press the button») and
turn off the power («release the button»).
A different combination of buttons and sequence of
keystrokes is allowed, e.g. if you press the button
#1 twice and press the button #2 once, the system
will save all the clicks in this order. When you have
finished entering the PIN-code, the system will
display 3 confirmation signals of LED or buzzer,
regardless the number of clicks.
6. Enter the current PIN-code once again. If the codes
are matched the indication signal will be given
twice. The indication will shift to quadruple signal,
once in 3 seconds.
7. Turn the ACC power on. The 5-fold indication signals
of the LED or buzzer will follow, once in 3 seconds.
8. Repeat the PIN-code setting according to the
paragraphs 5, 6. The PIN-code will be recorded .