AUTHOR Alarm Kvant 120, Operating Manual

Page: 12 / 32

12
If there are 4 indication signals, it means that the
PIN-codes do not match and PIN-code has not
been saved
. Repeat the steps 1-8 to set PIN-code.
9. Disconnect the red wire from DC+ in order to reboot
the device.
10. Connect the red wire to the power-supply circuit.
If necessary, connect the grey wire in order to use it
as an analogue button.
Having this procedure completed, you will be able to
use the buttons on the steering wheel to enter the PIN-
code, even if there is no vehicle battery voltage.
Change of PIN-code
To ensure the confidentiality the PIN-code set in
the service centre shall be changed when the car-
owner gets his/her car back from the service centre
with KVANT anti-theft system installed. Also it is
recommended to change a PIN-code if you suspect
someone has watched you entering the PIN-code.
1. Turn the ignition on without starting the engine
(only if the car does not recognise the clicking when
the ignition is off).
2. Enter the current PIN-code to authorize. There will
be 2 indication signals.
3. Enter the current PIN-code again within 2 minutes.
The device will pass to the PIN-code change mode
and the signal indication will be given every 3
seconds.
4. Enter the new PIN-code using the buttons connected
to the device inputs. Every pressing shall be followed
by the indication signal.